Ticket #14 - Repubished
14/08/10 20:14
I am reposting here Lab 14, which was published on ccieflyer.com. Next ticket, Ticket 15, which will be about multicast will be published on CCIEFlyer.com, then it will be republished here again. And so on for the next few Tickets.
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Network diagram
BGP diagram
IGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R1 can't telnet R6's Lo0. Find and fix the problem.For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Ticket #14
22/07/10 21:48
Ticket #13 - Republished
09/07/10 11:33
I am reposting here Lab 13, which was published on ccieflyer.com. Next ticket, Ticket 14, which will be about BGP, OSPF and telnet will be published on CCIEFlyer.com, then it will be republished here again. And so on for the next few Tickets.
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Network diagram
BGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R3 was configured to send to BB1 only routes originated in AS3. So only R3 can ping BB1 from its Lo0. However, its not working, as no router can ping BB1 from it's Lo0. Find and fix the problem.For the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Ticket #13
23/06/10 18:26
Ticket #11
15/04/10 20:49
Network diagram
IGP diagram
BGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R1 can’t ping R2’s Lo0 IP address. Fix the problemFor the solution Click here
For more mini labs, have a look at the mini labs page.
Also have a look at the complete troubleshooting workbook.
Ticket #03
23/11/09 22:54
Network diagram
BGP diagram
Lab file
This lab is using dynamips. Please follow the instructions found here about how to use the lab file.
The problem:
R2 has two BGP paths to R4's Lo0 IP address, however only one route is installed in it's routing table. Fix the problem.For the solution Click here